Administrator Guide

396 | Configuring Policy Simulation Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Table 217: Application Authentication - Attributes Tab Parameters
Attribute Parameter
Type Select Application or select Application:ClearPass. See Application Namespace on page 846
Name
The options displayed for the Name Attribute depend on the Type Attribute that was
selected.
Value
The options displayed for the Value Attribute depend on the Type Attribute and Name
Attribute that were selected.
Results tab
The Results tab of the Application Authentication simulation displays the outcome of the Authentication
Result and the Application Authentication Output Attributes. The following figure displays the
Application Authentication Results tab:
Figure 395: Application Authentication Results Tab
Parameter Description
Summary Displays the results of the Active Directory Authentication simulation.
Application Authentication
Output Attributes
Displays the output attributes, such as Super Administrator.
Table 218: Application Authentication Results Tab Parameters
Audit Simulation
This simulation allows you to specify an audit against a Nessus Server or Nmap Server with its IP address.
The Attributes tab is not available for this simulation type.
Audit simulations can take more than 30 minutes. An AuditinProgress status message is displayed until the audit is
completed.