Administrator Guide

Figure 404: RADIUS Authentication Simulation Details Dialog
4. Enter the values for each of the RADIUS Simulation parameters as described in Table 227.
Parameter Action/Description
Server 1. Specify Local or Remote.
CPPM IP Address or FQDN This field is displayed only if Remote Server is selected.
2. Enter the IP address or the fully qualified domain name (FQDN) of the remote
W-ClearPass Policy Manager server.
Shared Secret Displayed only if Remote Server is selected.
3. Enter the shared secret between the target W-ClearPass server and this node.
You must add the node as a Network Device on the target W-ClearPass server.
(For details, see Adding a Network Device on page 430).
NAS IP Address (optional) 4. To populate the NAS-IP-Address attribute in a RADIUS request, enter the IP
address of the network device.
NAS Type 5. Select the type of network device to simulate in terms of RADIUS attributes in
the request. The NAS types are:
n Dell Wireless Controller
n Dell Wired Switch
n Cisco Wireless Controller
n Generic
Table 227: RADIUS Simulation Tab Parameters
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Configuring Policy Simulation | 405