Administrator Guide

Figure 426: Profile Settings: Subnet Scans Dialog
2. In the Subnet Scans section, select a W-Policy Manager Zone by clicking Click to add.
If W-Policy Manager Zones have not yet been set up, you can select the default zone, which will allow you to proceed
with the configuration procedure.
After you select the Policy Manager Zone, the IPSubnet to Scan text field appears.
3. In the IP Subnet to Scan text field, enter the IPaddresses for the subnets you wish to scan, then click the
Save icon (see Figure 427).
Figure 427: Specifying the Subnets to Be Scanned
You return to the Subnet Scans dialog where the IP subnets are listed in the IPSubnet to Scan text field (see
Figure 428).
Initiating an On-Demand Subnet Scan
In cases in which you wish to initiate a subnet scan without saving the configuration, you can run an On-
Demand Subnet Scan.
To run an On-Demand Subnet Scan:
1. Navigate to Configuration > Profile Settings.
The Profile Settings dialog appears.
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide W-ClearPass Policy Manager Profile | 425