Administrator Guide

Parameter Action/Description
Name 1. Configure an optional enforcement policy based on the following attributes:
n Email
n Name
n Phone
n UserDN
n Company
n member of
n Title
For example, you can configure an enforcement policy for a contractor specifying that "If Name
equals <contractor_name>, then assign the [Contractor] Role."
Attribute
Value
2. Enter the active directory attribute value for the selected name in the Attribute Name field.
VLAN ID 3. Enter the standard RADIUS-IETF VLANID.
Wired Network Settings
Select Switch 1. Select any switch from the drop-down list.
Device Name 2. Enter the name of the device.
IP Address 3. Enter the IP address of the device.
Vendor Name 4. Select the manufacturer of the wired controller.
RADIUS
Shared Secret
5. Enter the shared secret that is configured on the controller and inside W-Policy Manager to
send and receive RADIUS requests.
Enable
RADIUS CoA
6. Select to enable RADIUS initiated Change of Authorization (CoA) on the network device.
RADIUS CoA
Port
Specifies the default port 3799 if RADIUS CoA is enabled.
7. Change this value only if you defined a custom port on the network device.
Wireless Network Settings
Wireless
controller
name
1. Enter the name of the wireless controller.
Controller
IPAddress
2. Enter the IP address of the wireless controller.
Vendor Name 3. Select the manufacturer of the wireless controller.
RADIUS
Shared Secret
4. Enter the shared secret that is configured on the controller and W-Policy Manager to send and
receive RADIUS requests.
Table 5: 802.1X Wired, 802.1X Wireless, and Dell W-Series 802.1X Wireless Service Template Parameters
(Continued)
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Services | 47