Administrator Guide

478 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Service Parameter Action/Description
Maximum Requests Specify a number between 0 and 3000 for the maximum number of requests allowed.
The default value is 500.
Enable Host Header
check
Specify whether to enable the host header check.
The default value is TRUE.
l When you set this value to TRUE, the Host Header Restriction check is enabled
and only the allowed or whitelisted host headers are allowed.
l When you set this value to FALSE, irrespective of Host Headers in the http packet,
W-ClearPass Policy Manager redirects to https://<W-ClearPass-server>/tips.
WhiteList Host Names When the Enable Host Header check value is set to TRUE, the web access is allowed
for Whitelist Host Names, hostnames, IP addresses, and VIP addresses in W-ClearPass
Policy Manager. The comma separated whitelist host names are allowed to support
multiple hostnames.
When the Enable Host Header check value is set to TRUE and the WhiteList Host
Names field is blank, the web access is allowed only for hostnames, IP addresses, and
VIP addresses in W-ClearPass Policy Manager.
Table 262: Service Parameters > W-ClearPass System Services (Continued)
Ingress Logger Service
When Ingress Event Processing is enabled and configured on W-ClearPass (see Configuring Processing for
Ingress Events on page 677), logging of ingress events occurs automatically.
By default, the W-ClearPass server listens for Ingress Events on TCP port 514 and UDP port 514.
If necessary, you can change these Syslog Ingress Logger ports. To do so:
1. Navigate to Administration > Server Manager > Server Configuration, then select the W-ClearPass
server.
2. Select the Service Parameters tab.
3. From the Select Service drop-down, select Ingress Logger Service.
The following dialog opens:
Figure 479: Ingress Logger Service Dialog
4. To change the Ingress Logger TCP Port, enter the new port number in the Parameter Value field.
5. To change the Ingress Logger UDP Port, enter the new port number.
6. Click Save.