Administrator Guide

Parameter Description
Security Level Select any of the following options:
l NOAUTH_NOPRIV (no authentication or privacy) - If you select this security level, only the SHA
authentication protocol is available.
l AUTH_NOPRIV (authenticate, but no privacy) - If you select this security level, the MD5 and
SHA authentication protocols are available.
l AUTH _PRIV (authenticate and keep the communication private) - If you select this security
level, the MD5 and SHA authentication protocols are available.
This field is available only if you selected V3 as the SNMP version in the Version field.
Authentication
Protocol
Select the authentication protocol from MD5 or SHA. These protocols vary depends on the
security level that you selected in the Security Level field. This field is available only if you
selected V3 as the SNMP version in the Version field.
NOTE: The MD5 authentication protocol is not supported in the FIPS mode.
Authentication
key
Enter and re-enter the authentication key. This field is available only if you selected V3 as the
SNMP version in the Version field.
Privacy
Protocol
Select the privacy protocol from DES or AES. This field is available only if you selected V3 as the
SNMP version in the Version field.
Privacy Key
Enter the privacy key. This field is available only if you selected V3 as the SNMP version in the
Version field.
Table 268: System Monitoring tab Parameters (Continued)
Network Tab
You can navigate to the Network page to perform the following tasks:
l Adding an SSH Public Key on page 488
l Creating GRETunnels on page 489
l Creating IPsec Tunnels on page 490
l Creating VLANs on page 492
l Defining Application Access Restrictions on page 493
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Administration | 487