Administrator Guide

l The server will be removed from the cluster if FIPS mode is enabled.
l All nodes in a cluster must be either in FIPS or non-FIPS mode. The W-ClearPass Policy Manager nodes in
FIPS mode cannot be connected to the cluster whose nodes are in the non-FIPS mode.
l The legacy authentication method such as EAP-MD5 and MD5 digest algorithm are not supported in FIPS
mode. You cannot import the certificates that are created with the MD5 authentication type to the
Certificates Trust List (Administration > Certificates > Certificate Trust List) page.
l The server reboots when you enable FIPS mode. You need to log in again to the Administration interface.
You can view the status of FIPS mode in the status bar. The following figure displays the Status bar with the
status of FIPS mode:
Figure 495: FIPS Status
You can also view the status of the FIPS mode using the CLI commands. For more information, see Show
Commands on page 760.
Set Date & Time
Click the Set Date and Time link under the Administration > Server Manager > Server Configuration
page to access the Change Date and Time pop-up where can set the date and time for the server.
The Change Date and Time pop-up has the following two tabs:
l Date&Time Tab on page 498
l Time Zone on Publisher Tab on page 498
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Administration | 497