Administrator Guide

586 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
c. Value: Enter 21600 (which equals six hours in seconds).
Tunnel-Type
6. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Tunnel-Type.
c. Value: Select VLAN.
Termination-Action
7. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Termination-Action.
c. Value: Select RADIUS-Request.
8. Click Save.
You return to the Enforcement Profiles page. The following message is displayed:
Enforcement profile "Infoblox RADIUS Enforcement" added
Creating an Infoblox Enforcement Policy
This section describes how to create an enforcement policy to act against the "Infoblox Notify" and "Infoblox
RADIUS Enforcement" profiles so that external devices can authenticate against this policy.
For details on configuring enforcement policies, see Configuring Enforcement Policies on page 343.
To create an Infoblox Enforcement Policy:
1. Navigate to Configuration > Enforcement > Policies.
The Enforcement Policies page opens.
2. Click Add.
The Add Enforcement Policies page appears.
Figure 584: Adding the Infoblox Enforcement Policy
3. Enter the following information:
a. Name: Enter Infoblox Policy.
b. Description: Optionally, enter a description of this profile.
c. Enforcement Type: Set by default to RADIUS.
d. Default Profile: Select Allow Access Profile.
e. Click Next.
The Rules page appears.