Administrator Guide

4. Enter the following information:
a. Authentication Methods: Select the authentication method.
This example uses EAP MSCHAPv2.
b. Authentication Sources: Select the authentication source(s).
This example uses Local SQL DB.
5. Select the Enforcement tab.
Figure 589: Specifying the Enforcement Policy for the Service
6. From the Enforcement Policy drop down, select Infoblox Policy, then click Next.
The Infoblox Wireless Service Summary page is displayed.
7. Check the summary information to make sure the service is correct, make any changes if necessary, then
click Save.
You return to the Services page where the new Infoblox Wireless Service is now listed.
Authenticating External Devices Against the Infoblox Service
This section defines the configuration on the Infoblox server to receive the MAC address and username
context from W-ClearPass.
The following procedure adds an IPv4 network that is used as a DHCP pool to assign IP addresses to the
external devices that must be authenticated.
To configure an Infoblox server to authenticate external devices:
1. Log into the Infoblox server.
The Infoblox IPAM Tasks page opens.
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Administration | 589