Administrator Guide

Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Command Line Interface | 735
Appendix A
Command Line Interface
Refer to the following sections to perform various tasks using the Command Line Interface (CLI):
l Cluster Commands on page 735
l Configure Commands on page 738
l Miscellaneous Commands on page 750
l Network Commands on page 743
l Service Commands on page 758
l Show Commands on page 760
l SSH Timed Account Lockout
l System Commands on page 769
Cluster Commands
The Policy Manager command line interface includes the following cluster commands:
l cluster drop-subscriber
l cluster list
l cluster make-publisher
l cluster make-subscriber
l cluster reset-database
l cluster set-cluster-passwd
l cluster sync-cluster-passwd
cluster drop-subscriber
Use the drop-subscriber command to remove a specific subscriber node from the cluster.
Syntax
cluster drop-subscriber [-f] [-i <IP address>] -s
Table 385 describes the required and optional parameters for the drop-subscriber command:
Parameter/Flag Description
-f Forces to drop even the nodes that are down.
-i <IP Address> Specifies the Management IP address of the node. If this IP address is not specified and the
current node is a subscriber, then W-Policy Manager drops the current node.
-s Restricts resetting the database on the dropped node.
By default, W-Policy Manager drops the current node—if it's a subscriber—from the cluster.
Table 385: Drop-Subscriber Command Parameters
Example
The following example removes the IP address 192.xxx.1.1 from the cluster: