Administrator Guide

740 | Command Line Interface Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Running this command erases the ClearPass Policy Manager configuration settings and returns the database to the
default configuration. All configured data will be lost. This command also shuts down all running applications and
reboots the system.
Syntax
configure fips-mode [0|1]
The following table describes the required and optional parameters for the configure fips-mode command:
Flag/Parameter Description
0 To disable FIPS mode, enter 0.
Read the warning message carefully before enabling or disabling FIPSmode.
1 To enable FIPS mode, enter 1.
Table 388: Configure fips-mode Command Parameters
Example 1
The following example disables FIPS mode:
[appadmin]# configure fips-mode 0
******************************************************************
* *
* WARNING: Running this command will erase the Policy Manager *
* configuration and leave the database with default *
* configuration. You will lose all the configured data. *
* *
* This command will also shutdown all applications and reboot *
* the system. *
* *
* Do not close the shell or interrupt this command execution. *
* *
******************************************************************
Continue? [y|n]: y
Clicking y in this example disables FIPSmode.
configure hostname
Use the configure hostname command to configure the hostname.
Syntax
configure hostname <hostname>
Example
The following example configures a hostname:
[appadmin]# configure hostname sun.us.dellnetworks.com
configure ip
Use the configure ip command to configure the IPv4 address of the management interface or the data
interface, netmask, and gateway address.