Administrator Guide

Flag/Parameter Description
data [v4|v6] Specifies the name of network data port to reset, as well as whether it is an IPv4 or IPv6
address. This parameter is mandatory.
mgmt Specifies the name of network management port to reset.
Table 398: Network Reset Command Parameters
Example
The following example resets the IPv6 network data port:
[appadmin]# network reset data v6
network traceroute6
Use the network traceroute6 command to print the route taken to reach the IPv6 network host.
Syntax: network traceroute6
network traceroute6 <host>
The following table describes the required and optional parameters for the network traceroute6 command:
Flag/Parameter Description
<host> Specifies the name of network host. You can specify the host with an IPv6 address.
Table 399: Network Traceroute6 Command Parameters
Example
The following example prints the route taken to reach the network host:
[appadmin]# network traceroute6 sun.us.dellnetworks.com
network traceroute
Use the network traceroute command to print the route taken to reach the network host.
Syntax: network traceroute
network traceroute <host>
The following table describes the required parameter for the network traceroute command:
Flag/Parameter Description
<host> Specifies the name of the network host.
Table 400: Network Traceroute Command Parameters
Example
The following example prints the route taken to reach the network host:
[appadmin]# network traceroute sun.us.dellnetworks.com
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Command Line Interface | 749