Administrator Guide

762 | Command Line Interface Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
show fipsmode
Use the show fipsmode command to find whether FIPS (Federal Information Processing Standard) mode is
enabled or disabled.
Example
The following example shows that FIPS mode is enabled:
[appadmin]# show fipsmode
FIPS Mode: Enabled
show hostname
Use the show hostname command to view the hostname of the current W-ClearPass server.
Syntax
show hostname
Example
The following displays an example of the show hostname command:
[appadmin]# show hostname
cppm.chicago.1
show ip
Use the show ip command to view the IPv4, IPv6, and DNS information of the host.
Syntax
show ip
Example
The following example of the show ip command displays the IPv4, IPv6, and DNS information of the host:
[appadmin]# show ip
===========================================
Device Type : Management Port
-------------------------------------------
IPv4 Address : 10.2.xx.86
Subnet Mask : 255.255.255.0
Gateway : 10.2.xx.1
IPv6 Address : 2607:f0d0:1002:0011:0000:0000:0000:0002
Subnet Mask : ffff:ffff:ffff:ffff:0000:0000:0000:0000
Gateway : 2607:f0d0:1002:0011:0000:0000:0000:0001
Hardware Address : 00:0C:29:70:27:40
MTU : 1499
===========================================
Device Type : Data Port
-------------------------------------------
IPv4 Address : <not configured>
Subnet Mask : <not configured>
Gateway : <not configured>
IPv6 Address : fe80:0000:0000:0000:020c:29ff:fe70:274a
Subnet Mask : ffff:ffff:ffff:ffff:0000:0000:0000:0000
Gateway : fe80:0000:0000:0000:020c:29ff:fe70:2741