Users Guide

To modify an existing service, click on its name in the Configuration > Services page. This opens the Services >
Edit - < service_name > form. Select the Service tab on this form to edit the service information.
Figure 49: Services Configuration
The following fields are available on the Service tab.
Table 42: Service Page (General Parameters)
Label Description
Name Enter or modify the label for a service.
Description Enter or modify the service description (optional).
Type This is a non-editable label that shows the type of service as it was originally configured.
Status This non-editable label indicates whether the service is enabled or disabled.
NOTE: You can disable a service by clicking the Disable button on the bottom-right corner of the
form.This button will toggle between Enable and Disable depending on the Service's current status.
Monitor
Mode
This non-editable check box indicates whether authentication and health validation exchanges will
take place between endpoint and Policy Manager, but without enforcement. In monitor mode, no
enforcement profiles (and associated attributes) are sent to the network device.
More
Options
Select the available check box(es) to view additional configuration tab(s). The options that are
available depend on the type of service currently being modified. TACACS+ Service, for example,
allows for authorization configuration.RADIUS Service allows for configuration of posture
compliance, end hosts, profile endpoints, and authorization.
On the lower half of the form, select an available rule within the Service Rule table. The following fields are available.
Table 43: Service Page (Rules Editor)
Label Description
Type The rules editor appears throughout the Policy Manager interface. It exposes different namespace
dictionaries depending on Service type. When working with service rules, you can select from the
following namespace dictionaries:
l Application: The type of application for this service.
Dell Networking W-ClearPass Policy Manager 6.0 | User Guide 105