Users Guide

36 Dell Networking W-ClearPass Policy Manager 6.0 | User Guide
Container Description
Manager, and SNMP read and write parameters
must be configured.
l SNMP traps (link up and/or MAC notification)
have to enabled on the switch port.
l In order to specify the IP address of the endpoint
to bounce, the DHCP snooper service on Policy
Manager must receive DHCP packets from the
endpoint. Refer to your network device
documentation to find out how to configure IP
helper address.
Broadcast Message Send a message to all active endpoints
Send Message Send a message to the selected endpoints.
Bounce Initiate a bounce on the managed interface on the
endpoint.
l Display Message - An optional message to
display on the endpoint (via the OnGuard
interface).
l Web link - An optional clickable URL that is
displayed along with the Display Message.
l Endpoint Status -
No change - No change is made to the status of
the endpoint. The existing status of Known,
Unknown or Disabled continues to be applied.
Access control is granted or denied based on the
endpoint’s existing status.
Allow network access - Always allow network
access. Whitelist this endpoint. Note that this
action just sets the status of the endpoint as
“Known”. You need to configure Enforcement
Policy Rules to allow access to “Known”
endpoints.
Block network access - Always block network
access. Blacklist this endpoint. Note that this
action just sets the status of the endpoint as
“Disabled”. You need to configure Enforcement
Policy Rules to allow access to “Disabled”
endpoints.
This action results in tags being created for the
specified endpoint in the Endpoints table
(Configuration > Identity > Endpoints). One or more of
the following tags are created: Disabled by, Disabled
Reason, Enabled by, Enabled Reason, Info URL.