Users Guide

l Errors (fps) Graph
Figure 189 - Errors (fps) Graph
To see the graphs for the 5 GHz band, click the 5 GHz link.
For more information about the graphs in the instant access point view and for monitoring
procedures, see Table 42.
Graph
Name
Description Monitoring Procedure
Utilization
The Utilization graph shows the radio
utilization percentage of the access
point for the last 15 minutes.
To see an enlarged view, click the
graph.The enlarged view provides
Last, Minimum, Maximum, and
Average radio utilization statistics for
the W-IAP for the last 15 minutes.
To see the exact utilization percent at
a particular time, hover the cursor over
the graph line.
To monitor the utilization of the
selected W-IAP for the last 15
minutes,
1. Log in to the Dell W-Series
Instant UII. The Virtual Controller
view appears. This is the default
view.
2. In the Access Points tab, click
the W-IAP for which you want to
monitor the utilization. The W-IAP
view appears.
3. Study the Utilization graph in the
RF Trends pane. For example, the
graph shows 84% W-IAP radio
utilization for the 2.4 GHz band at
12:15 hours.
NOTE: You can also click the
rectangle icon under the Utilization
column in the RF Dashboard pane to
see the Utilization graph for the
selected W-IAP. The rectangle icon
is seen as follows:
2.4 GHz
Frames
The 2.4 GHz Frames graph shows the
In and Out frame rate per second for
the radio in 2.4 GHz band for the last 15
minutes.
l Outgoing frames — Outgoing frame
traffic is displayed in green. It is
To monitor the In and Out frame rate
per second for the radio in 2.4 GHz
band, for the last 15 minutes,
1. Log in to the Dell W-Series
Instant UI. The Virtual Controller
view appears. This is the default
Table 42 - DellW-Instant Access Point View — RF Trends Graphs and Monitoring
Procedures
Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 241 | Monitoring