Users Guide

Testing
1. Disconnect your AppleTV and OSX Mountain Lion/iOS 6 devices if they were previously
connected to the wireless network. Remove their entries from the controller’s user table using
these commands:
n Find the MAC address— show user table
n Delete the address from the table— aaa user delete mac
00:aa:22:bb:33:cc
2. Reconnect both devices. To limit access to the AppleTV, access the Dell PowerConnect W-
ClearPass Guest UI using either the AirGroup admin or the AirGroup operator credentials.
Next, navigate to List Devices > Test Apple TV > Edit. Add a username that is not used to
log in to the Apple devices in the Shared With field.
3. Disconnect and remove the OSX Mountain Lion/iOS 6 device from the controller’s user table.
Reconnect the device by not using the username that you added to the Shared With field.
The AppleTV should not be available to this device.
4. Disconnect the OSX Mountain Lion/iOS 6 device and delete it from the controller’s user
table. Reconnect using the username that was added to the Shared With field. The OSX
Mountain Lion/iOS 6 device should once again have access to the AppleTV.
Troubleshooting
Table 48- Troubleshooting
Problem Solution
Limiting devices has no effect. Ensure IPv6 is disabled.
Apple Macintosh running Mountain Lion
can use AirPlay but iOS devices cannot.
Ensure IPv6 is disabled.
Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide
283 | Dell PowerConnect W-Clear-
Pass Configuration for AirGroup