Users Guide

72 | Managing W-IAPs Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide
Figure 44 - Disabling Auto Join Mode
3. Click OK.
Terminal Access
Instant supports terminal access for diagnostic purpose only. To enable or disable the SSH access
to the W-IAPs CLI, navigate to Settings > Advanced > Terminal access.
NOTE: Telnet access to the CLI has been deprecated as of the 6.2.0.0-3.2.0.0 release. As of
that release, when the Terminal Access option is enabled, only SSH access to the CLI will
be possible.
NOTE: W-Instant does not support configuration using CLI.
LED Display
Administrators have the ability to turn off LED for all W-IAPs in an Instant network. Navigate to
Settings > Advanced > LED Display to enable or disable the LEDs. When Disabled, all the
LEDs are turned off. Use this option in environments where LEDs can be a distraction.
NOTE: The LED display is always in Enabled mode while rebooting the W-IAP.
TFTP Dump Server
Enter the IP address of a TFTP server to store core dump files.