Users Guide
Figure 46 - Adding aW-IAP to the Instant Network
2. In the New Access Point window, enter the MAC address for the new W-IAP.
Figure 47 - Entering the MAC Address for the New W-IAP
3. Click OK.
Removing aW-IAP from the Network
AW-IAP can be manually removed from the network only if the "Auto Join Mode" on page 71
feature is disabled.
To manually remove aW-IAP from the network:
1. In the Access Points tab, click the W-IAP which you want to delete. An x appears against the
W-IAP.
2. Click x to confirm the deletion.
NOTE: The deleted W-IAP(s) cannot join the W-Instant network anymore and no longer
appear in the Dell W-Series Instant UI. However, the master W-IAP cannot be deleted from
the Virtual Controller.
Editing W-IAP Settings
This section explains how to change the W-IAP settings such as Name, IP Address and steps for
configuring Adaptive Radio Management (ARM), Wired Bridging on Ethernet 0 Port, Uplink
Management VLAN, and migrating from a Virtual Controller Managed Network to Mobility
Controller Managed Network.
Changing W-IAP Name
To change the W-IAP name:
1. In the Access Points tab, click on the W-IAP that you want to rename.
Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 75 | Managing W-IAPs