Reference Guide

hotspot h2qp-wan-metrics-profile
hotspot h2qp-wan-metrics-profile <profile-name>
at-capacity
downlink-load <load>
downlink-speed <speed>
enable
load-duration <duration>
symm-link
uplink-load <load>
uplink-speed <speed>
wan-metrics-link-status <status>
no…
Description
This command configures a Hotspot 2.0 Query Protocol (H2QP) profile that specifies the hotspot WAN status and
link metrics.
Syntax
Parameter Description Range Default
hotspot h2qp-wan-
metrics-profile
<profile-name>
Creates a H2QP WAN metric profile — —
at-capacity
Indicates if the WAN Link has reached its
maximum capacity. If this parameter is enabled,
no additional mobile devices will be permitted to
associate to the hotspot W-IAP.
— —
downlink-load
<load>
Configures the percentage of the WAN downlink
that is currently utilized. If no value is set, this
parameter will show a default value of 0 to
indicate that the downlink speed is unknown or
unspecified.
1-100 0
(unspecified)
downlink-speed
<speed>
Indicates the current WAN backhaul downlink
speed in Kbps. If no value is set, this parameter
will show a default value of 0 to indicate that the
downlink speed is unknown or unspecified.
0 -
2,147,483,64
7 Kbps
0
(unspecified)
enable
Enables the H2QP WAN metrics profile.
— —
load-duration
<duration>
Configures a duration at which the downlink load
is measured, in tenths of a second.
0 and 65535 —
symm-link
Indicates that the WAN Link has same speed in
both the uplink and downlink directions.
— —
no
Removes any existing configuration.
— —
uplink-load <speed>
The percentage of the WAN uplink that is
currently utilized. If no value is set, this parameter
will show a default value of 0 to indicate that the
downlink speed is unknown or unspecified.
1-100 0
(unspecified)
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide hotspot h2qp-wan-metrics-profile | 111