Reference Guide

112 | hotspot h2qp-wan-metrics-profile Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
Parameter Description Range Default
uplink-speed
<speed>
Use the uplink <speed> parameter to indicate the
current WAN backhaul uplink speed in Kbps. If no
value is set, this parameter will show a default
value of 0 to indicate that the uplink speed is
unknown or unspecified.
0 -
2,147,483,64
7 kbps
0
(unspecified)
wan-metrics-link-
status
Define the status of the WAN Link by configuring
one of the following values.
— —
<status>
Configures any of the following states:
l link-up— Indicates if WAN link is up.
l link-down— Indicates if WAN link is down
l link-under-test—Indicates if WAN link is
currently in a test state.
link-down,
link-under-
test, link-up
unspecified
Usage Guidelines
Use this command to configure the values be sent in an H2QP IE to provide information about access network
characteristics such as link status and the capacity and speed of the WAN link to the Internet.
Examples
The following example configures a WAN metric profile:
(Instant AP)(config)# hotspot h2qp-wan-metrics-profile Wan1
(Instant AP)(WAN-metrics "Wan1")# at-capacity
(Instant AP)(WAN-metrics "Wan1")# downlink-load 5
(Instant AP)(WAN-metrics "Wan1")# downlink-speed 147
(Instant AP)(WAN-metrics "Wan1")# load-duration 60
(Instant AP)(WAN-metrics "Wan1")# symm-link
(Instant AP)(WAN-metrics "Wan1")# uplink-load 10
(Instant AP)(WAN-metrics "Wan1")# uplink-speed 147
(Instant AP)(WAN-metrics "Wan1")# wan-metrics-link-status link_up
(Instant AP)(WAN-metrics "Wan1")# end
(Instant AP)# commit apply
Command History
Version Description
Dell Networking W-Series Instant 6.2.1.0-
3.3
This command is introduced.
Command Information
W-IAP Platform Command Mode
All platforms
Configuration mode and the H2QP WAN metrics profile
configuration sub-mode