Reference Guide

148 | l3-mobility Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
l3-mobility
l3-mobility
home-agent-load-balancing
virtual-controller <IP-address>
subnet <IP-address-subnet> <subnet-mask> <vlan> <virtual-controller-IP-address>
no...
Description
This command configures Layer-3 mobility on a W-IAP.
Syntax
Parameter Description Range Default
l3-mobility
Enables Layer-3 mobility configuration sub-
mode.
— —
home-agent-load-
balancing
Enables home agent load balancing.
When enabled, the Virtual Controller assigns
the home AP for roamed clients by using a
round robin policy. With this policy, the load
for the APs acting as Home Agents for
roamed clients is uniformly distributed across
the W-IAP cluster.
— Disabled
virtual-controller
<IP-address>
Adds the IP address of a Virtual Controller to
the mobility domain.
In the typical deployment scenario, all the APs
are configured in one subnet and all the
clients in another subnet.
You can also deploy APs across different
subnets, in which case the APs in each
subnet will form a cluster with its own Virtual
Controller IP address. To allow clients to roam
seamlessly among all the APs, the Virtual
Controller IP for each of the foreign subnets
must be configured for each W-IAP cluster.
— —
<IP-address>
Configures the IP address for the subnets
support in a W-IAP cluster.
— —
subnet <subnet-mask>
Specifies the subnet mask. — —
<vlan>
Assigns the VLAN applicable to the W-IAP
cluster.
1-4093 —
<virtual-controller
IP>
Specifies the IP address of the Virtual
Controller in a W-IAP cluster.
— —
no…
Removes the configuration. — —
Usage Guidelines
Use this command to configure layer-3 mobility domains on a W-IAP.
Example
The following example configures L3-mobility: