Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsW-IAP175P/AC
151152153154155156157158159160
152 | mas-integration Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
mas-integration
mas-integration
no…
Description
This command enables Mobility Access Switch integration on a W-IAP.
Syntax
Parameter Description
mas-integration
Enables you to integrate the W-IAP with a Mobility Access Switch.
no…
Removes the configuration.
Usage Guidelines
Use this command to integrate Mobility Access Switch with a W-IAP.
You can integrate a W-IAP with a Mobility Access Switch by connecting it directly to the switch port. The following
Mobility Access Switch integration features can be applied while integrating with a W-IAP:
l Rogue AP containment—When a rogue AP is detected by a W-IAP, it sends the MAC Address of the rogue AP
to the Mobility Access Switch. The Mobility Access Switch blacklists the MAC address of the rogue AP and
turns off the PoE on the port.
l PoE prioritization— When a W-IAP is connected directly into the Mobility Access Switch port, the Mobility
Access Switch port increases the PoE priority of the port. This is done only if the PoE priority is set by default in
the Mobility Access Switch.
The PoE Prioritization and Rogue AP Containment features is available for ArubaOS 7.2 release on Dell Mobility
Access Switches.
l GVRP Integration—Configuring GARP VLAN Registration Protocol (GVRP) enables the switch to dynamically
register or de-register VLAN information received from a GVRP applicant such as a W-IAP. GVRP also enables
the switch to propagate the registered VLAN information to the neighboring switches in the network.
The associated static VLANs in the wired and wireless profiles are propagated to the upstream Mobility Access
Switch using GVRP messages.
When a W-IAP is integrated with a Mobility Access Switch, the Link Layer Discovery Protocol (LLDP) is enabled.
Using this protocol, the W-IAPs instruct the Mobility Access Switch to turn off the ports where rogue APs are
connected, perform actions such as increasing the PoE priority, and configure the VLANs on the ports to which the
W-IAPs are connected.
Example
The following example enables Mobility Access Switchintegration for a W-IAP:
(Instant AP)(config)# mas-integration
(Instant AP)(config# end
(Instant AP)# commit apply