Reference Guide

pppoe-uplink-profile
pppoe-uplink-profile <profile>
pppoe-username <username>
pppoe-passwd <password>
pppoe-svcname <svcname>
pppoe-chapsecret <password>
pppoe-unnumbered-local-l3-dhcp-profile <dhcp-profile>
no…
Description
Use this command to configure PPPoE uplink profile.
Syntax
Parameter Description
pppoe-uplink-profile <profile>
Creates an uplink profile and enables the PPPoE uplink profile
configuration mode.
pppoe-username <username>
Configures a user name to allow a user to log into the DSL network.
pppoe-passwd <password>
Configures a password for the user to log into the DSL network.
pppoe-svcname <svcname>
Specifies the PPPoE service provided by your service provider.
pppoe-chapsecret <password>
Configures a secret key used for Challenge Handshake
Authentication Protocol (CHAP) authentication.
You can use a maximum of 34 characters for the CHAP secret key.
pppoe-unnumbered-local-l3-
dhcp-profile <dhcp-profile>
Configures the Local,L3 DHCP gateway IP address as the local IP
address of the PPPoE interface. When configured, the local interface
acts as an unnumbered PPPoE interface and allows the entire
Local,L3 DHCP subnet to be allocated to clients.
no…
Removes the configuration.
Usage Guidelines
Use this command to configure PPPoE uplink connection for a W-IAP.
Example
The following example configures the PPPoE uplink on a W-IAP:
(Instant AP)(config) # pppoe-uplink-profile
(Instant AP)(pppoe-uplink-profile)# pppoe-username User1
(Instant AP)(pppoe-uplink-profile)# pppoe-passwd Password123
(Instant AP)(pppoe-uplink-profile)# pppoe-svcname internet03
(Instant AP)(pppoe-uplink-profile)# pppoe-chapsecret 8e87644deda9364100719e017f88ebce
(Instant AP)(pppoe-uplink-profile)# pppoe-unnumbered-local-l3-dhcp-profile dhcpProfile1
(Instant AP)(pppoe-uplink-profile)# end
(Instant AP)# commit apply
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide pppoe-uplink-profile | 167