Reference Guide

170 | reload Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
reload
reload <all>
Description
This command performs a reboot of the Virtual Controller.
Syntax
Parameter Description
<all>
Reloads all W-IAPs in a cluster.
Usage Guidelines
Use this command to reboot a W-IAP after making configuration changes or under the guidance of Dell Networks
customer support. The reload command powers down the W-IAP, making it unavailable for configuration. After the
W-IAP reboots, you can access it via a local console connected to the serial port, or through an SSH, Telnet, or UI
session. If you need to troubleshoot the W-IAP during a reboot, use a local console connection.
After you use the reload command, the W-IAP prompts you to confirm this action. If you have not saved your
configuration, the W-IAP returns the following message:
Do you want to save the configuration (y/n):
l Enter y to save the configuration.
l Enter n to not save the configuration.
l Press [Enter] to exit the command without saving changes or rebooting the W-IAP.
If your configuration has already been saved, the W-IAP returns the following message:
Do you really want to reset the system(y/n):
l Enter y to reboot the W-IAP.
l Enter n to cancel this action.
The command will timeout if you do not enter y or n.
Example
The following command assumes you have already saved your configuration and you must reboot the W-IAP:
The W-IAP returns the following messages:
Do you really want to reset the system(y/n): y
System will now restart!
...
Restarting system.
Command History
Version Description
Dell Networking W-Series
Instant 6.2.1.0-3.3
This command is introduced.