Reference Guide

216 | show aps Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show aps
show aps [scanning][sync]
Description
This command displays all active W-IAPs, W-IAP scanning, and synchronization status.
Syntax
Parameter Description
aps
Displays the list of all active W-IAPs in the cluster.
aps scanning
Displays W-IAP scanning details.
aps sync
Displays W-IAP synchronization details.
Usage Guidelines
Use this command to view the list of active W-IAPs, W-IAP scanning and synchronization details.
Example
The following output is displayed for the show aps command:
AP List
-------
Name IP Address Mode Spectrum Clients Type Mesh Role 2.4 Channel
---- ---------- ---- -------- ------- ---- --------- ----------
d8:c7:c8:cb:d4:20 10.17.88.188 access disable 1 135 Portal 7
2.4 Power (dB) 2.4 Utilization (%) 2.4 Noise Floor (dBm) 5.0 Channel 5.0 Power (dB)
--------------- ------------------- --------------------- ---------- ------------
21 52(ok) -91(good) 44+ 22
5.0 Utilization (%) 5.0 Noise Floor (dBm) Need Antenna Config From Port Config Id
------------------- ---------------------- ------------------- --------- ------
3(good) -91(good) No none 1
The output of this command includes the following parameters:
Column Description
Name
Displays the Name of the W-IAPs.
IP address
Displays the IP address of the W-IAPs.
Mode
Displays the operating mode. For example, access, monitor, or spectrum monitor
modes.
Spectrum
Indicates if spectrum monitoring is enabled or disabled.
Client
Indicates the number of client associated with the W-IAP.
Type
Displays the W-IAP model.