Reference Guide

Column Description
Mesh Role
Indicates if the W-IAP is functioning as Mesh Point or mesh Portal.
2.4 Channel
Indicates the channels used by the W-IAP in the 2.4 GHz band.
2.4 Power(dB)
Indicates the transmission power allocated for 2.4 Ghz band channels.
2.4 Utilization
Indicates the percentage of utilization of 2.4 GHz channels.
2.4 Noise Floor
Indicates the noise floor of the 2.4 GHz channels.
5.0 Channel
Indicates the channels used by the W-IAP in the 5 GHz band.
5.0 Power(dB)
Indicates the transmission power allocated for 5 GHz band channels.
5.0 Utilization
Indicates the percentage of utilization of 5 GHz channels.
5.0 Noise Floor
Indicates the noise floor of the 5 GHz channels.
Need antenna config
Indicates if antenna configuration is required.
From port
Indicates the port details if any.
Config Id
Indicates the configuration ID.
The following output is displayed for the show aps scanning command:
AP Scanning Stats
-----------------
Name IP Address 2.4 Reqs 2.4 Voice Rejs 2.4 Video Rejs 5.0 Reqs
---- ---------- -------- -------------- -------------- -----
d8:c7:c8:cb:d4:20 10.17.88.188 5665 0 0 5675
5.0 Voice Rejs 5.0 Video Rejs
-------------- --------------
0 0
The output of this command includes the following parameters:
Column Description
Name
Displays the Name of the W-IAP.
IP address
Displays the IP address of the W-IAP.
2.4 Reqs
5.0 Reqs
Displays the counters that indicate channel scanning requirements.
2.4 Voice Rejs
5.0 Voice Rejs
Displays the counters that indicate the number of scanning rejects due to voice
traffic.
2.4 Video Rejs
5.0 Video Rejs
Displays the counters that indicate the number of scanning rejects due to voice
traffic.
The following output is displayed for the show aps scanning command:
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide show aps | 217