Reference Guide

show ap debug am-config
show ap debug am-config
Description
This command displays the information required for debugging a W-IAP.
Syntax
Parameter Description
mac
MAC address in the trace buffer.
Example
The following example shows the partial output of show ap debug am-config command:
Channel Number
--------------
1
7
Valid 40MHz A-Channel Pairs
----------------------------
Channel Number
--------------
36
44
52
60
149
157
AP System Configuration
-----------------------
Parameter Value
--------- -----
AM Scan RF Band all
RF Behavior Configuration
-------------------------
Parameter Value
--------- -----
Station Handoff Assist Disable
RSSI Falloff Wait Time 0
Low RSSI Threshold 0
RSSI Check Frequency 0
Event Thresholds Configuration
------------------------------
Parameter Value
--------- -----
Detect Frame Rate Anomalies Disable
Bandwidth Rate High Watermark 0
Bandwidth Rate Low Watermark 0
Frame Error Rate High Watermark 0
Frame Error Rate Low Watermark 0
Frame Fragmentation Rate High Watermark 0
Frame Fragmentation Rate Low Watermark 0
Frame Low Speed Rate High Watermark 0
Frame Low Speed Rate Low Watermark 0
Frame Non Unicast Rate High Watermark 0
Frame Non Unicast Rate Low Watermark 0
Frame Receive Error Rate High Watermark 0
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide show ap debug am-config | 253