Reference Guide
Parameter Description
l num-beacons: Number of beacons seen during a 10-second scan
l tot-beacons: Total number of beacons seen since the last reset.
l num-frames: Total number of frames seen since the last rest.
l mt: Monitor time; the number of timer ticks elapsed since the first AP is
recognized.
l at: Active time, in timer ticks.
l ibss: Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the bssid
has detected an ad-hoc BSS (an ibss bit in an 802.11 frame).
l rssi: The Receive Signal Strength Indicator (RSSI) value displayed in the
output of this command represents signal strength as a signal to noise ratio.
For example, a value of 30 would indicate that the power of the received signal is
30 dBm above the signal noise threshold.
pot-sta-list
Shows the Potential client table. The Potential Client table shows the following
values:
l last-bssid: the Last BSSID to which the client associated.
l from-bssid,
l to-bssid
l mt:Monitor time; the number of timer ticks elapsed since the first client is
recognized.
l it: Client Idle time, expressed as a number of timer ticks.
routers
Shows Router MAC Addresses learned. The output of this command includes the
router’s MAC address, IP address and uptime.
scan-info
Shows scanned information for the W-IAP.
sta-list
Shows the configuration and status of monitor information of the W-IAP.
state
Shows the AP monitoring state.
stats
Shows the AP monitoring statistics.
status
Shows the status of the AP monitoring.
Examples
show ap monitor active-laser-beams
The following example shows the output of show ap monitor active-laser-beams command:
Active Laser Beam Sources
-------------------------
bssid channel rssi ap name lms ip master ip inactive time
----- ------- ---- ------- ------ --------- -------------
show ap monitor ap-list
The following example shows the output of show ap monitor ap-list command:
Monitored AP Table
------------------
bssid essid chan ap-type phy-type dos dt/mt ut/it encr nstas avg-rssi curr-rssi wmacs ibss
----- ----- ---- ------- -------- --- ----- ----- ---- ----- -------- --------- ----- ----
d8:c7:c8:3d:3a:93 rahul_wep 149 interfering 80211a-HT-40 disable 3904/36 97/0 wep 0 0 20 0 no
00:24:6c:80:7d:11 NTT-SPOT 1 interfering 80211b/g disable 3897/3897 9/8 wep 0 9 11 0 no
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide show ap monitor | 293