Reference Guide

318 | show blacklist-client Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show blacklist-client
show blacklist-client [config]
Description
This command shows the configuration details for blacklisting clients and lists the clients blacklisted by W-IAP.
Syntax
Parameter Description
config
Displays the parameters and values configured for manual or dynamic blacklisting of
clients.
Usage Guidelines
Use this command to view information about the clients blacklisted by a W-IAP.
Example
The following output is displayed for the show blacklist-client command:
Blacklisted Clients
-------------------
MAC Reason Timestamp Remaining time(sec) AP name
--- ------ --------- ------------------- -------
00:24:6c:ca:41:51 user-defined 14:46:18 Permanent -
The output of this command provides information on the MAC address of client that is blacklisted, the reason for
blacklisting, timestamp, the associated W-IAP name, and the duration until which the client is blacklisted.
The following output is displayed for the show blacklist-client config command:
Blacklist Time :3600
Auth Failure Blacklist Time :3600
Manually Blacklisted Clients
----------------------------
MAC Time
--- ----
00:24:6c:ca:41:51 14:46:18
Dynamically Blacklisted Clients
-------------------------------
MAC Reason Timestamp Remaining time(sec) AP name
--- ------ --------- ------------------- -------
Dyn Blacklist Count :0
The output of this command provides the following information:
Parameter Description
Blacklist Time
Indicates the duration in seconds since the blacklisting has been
triggered due to an ACL rule.
auth-survivability cache-time-
out
Indicates the duration in seconds after which the clients that exceed
the maximum authentication failure threshold are blacklisted.