Reference Guide

34 | arm Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
Command/Parameter Description Range Default
error, 2—
information,
3—debug,
4—dump
holdtime <number>
Configures a hold time for client match. 1—1800 900
max-adoption <count>
Configure a maximum number for adopting
clients.
0-100 5
max-request <count>
Configures the maximum number of
requests for client match.
0-100 5
nb-matching <percentage>
Configures a percentage value to be
considered in the same virtual RF
neighborhood of Client match.
20-100% 75%
slb-mode <mode>
Configures a balancing strategy for client
match.
1—3
1—Channel-
based
2—Radio-
based
3—Channel
and Radio
based
1
g-channels <g-channel>
Configures 2.4 GHz channels. — —
min-tx-power <power>
Sets the minimum transmission power. This
indicates the minimum Effective Isotropic
Radiated Power (EIRP). If the minimum
transmission EIRP setting configured on an
AP is not supported by the AP model, this
value is reduced to the highest supported
power setting.
0-127 dBm 18
max-tx-power <power>
Sets the highest transmit power levels for
the AP. If the maximum transmission EIRP
configured on an AP is not supported by the
AP model, the value is reduced to the
highest supported power setting.
NOTE: Higher power level settings may be
constrained by local regulatory
requirements and AP capabilities.
0-127 dBm 127
scanning
Allows the W-IAPs to scan other channels
for RF Management and Wireless Intrusion
Protection System enforcement.
— Disabled
wide-bands {<none>| <all>|
<2.4>| <5>}
Allows administrators to configure 40 MHz.
channels in the 2.4 GHz and 5.0 GHz
bands. 40 MHz channels are two 20 MHz
adjacent channels that are bonded
together. The 40 MHz channels double the
none, all,
2.4, and 5
5