Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsW-IAP175P/AC
351352353354355356357358359360
354 | show datapath Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show datapath user
The following example shows the partial output of show datapath user command.
Datapath User Table Entries
---------------------------
Flags: P - Permanent, W - WEP, T- TKIP, A - AESCCM
R - ProxyARP to User, N - VPN, L - local
FM(Forward Mode): S - Split, B - Bridge, N - N/A
IP MAC ACLs Contract Location Age Sessions Flags Vlan FM
--------------- ----------------- ------- --------- -------- ----- --------- ----- ---- --
10.17.88.59 D8:C7:C8:C4:42:98 105/0 0/0 0 0 1/65535 1 N
0.0.0.0 D8:C7:C8:C4:42:98 105/0 0/0 0 0 0/65535 P 1 N
192.168.10.1 D8:C7:C8:C4:42:98 105/0 0/0 0 11115 0/65535 P 3333 B
show datapath vlan
The following example shows the partial output of show datapath vlan command.
Datapath VLAN Table Entries
---------------------------
Flags: N - Nat Inside, M - Route Multicast, R - Routing
S - Snoop MLD, G - Snoop IGMP, P - Proxy IGMP
VLAN Flags Ports
---- ------ -----
1 R dev3
1 R dev11
1 R dev12
1 R dev13
1 R dev14
The outputs of the show datapath command indicates the following:
l ACL table allocation details for the W-IAP.
l AP Datapath ACL Tables
l List of ACL rules configured for the SSID and Ethernet port profiles.
l Bridge table entry statistics including MAC address, VLAN, assigned VLAN, destination and flag information for
the W-IAP.
l Details of a DMO session.
l Multicast table statistics for the W-IAP.
l Route table statistics for the W-IAP.
l Datapath session table statistics for the W-IAP
l Hardware packet statistics for the W-IAP.
l Datapath user statistics such as current entries, pending deletes, high water mark, maximum entries, total
entries, allocation failures, invalid users, and maximum link length for the W-IAP.
l VLAN table information such as VLAN memberships inside the datapath including L2 tunnels for the W-IAP.
Command History
Version Description
Dell Networking W-Series
Instant 6.3.1.1-4.0
This command is modified.
Dell Networking W-Series
Instant 6.2.1.0-3.3
This command is introduced.