Reference Guide

364 | show distributed-dhcp-branch-counts Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show distributed-dhcp-branch-counts
show distributed-dhcp-branch-counts <type> <sip> <eip>
Description
This command displays the branch count for the distributed DHCP scopes configured on a W-IAP.
Syntax
Parameter Description
type
Displays the branch details for the distributed DHCPs based on the type of the DHCP
scope specified. The current release of Instant supports the following distributed DHCP
assignment modes.
l Distributed, L2
l Distributed, L3
<sip>
<eip>
Filters the branch count information based on an IP address range specified for the
starting IP address <sip> and ending IP address parameters. You can specify up to four
different ranges of IP addresses to filter the command output.
Usage Guidelines
Use this command to view branch details for the distributed DHCP scopes.
Example
The following example shows the output of the show distributed-dhcp-branch-counts command:
Branch Count Table
------------------
Client Count Upto Branch Count
----------------- ------------
1 10
2 4
3 3
7 1
The output of this command displays the following information:
Parameter Description
Client Count Upto
Displays the number of clients allowed for each DHCP branch.
Branch Count
Displays the number of branches allowed for the specified range of IP
addresses.
Command History
Version Description
Dell Networking W-Series Instant 6.2.1.0-3.3
This command is introduced.