Reference Guide

show l3-mobility
show l3-mobility {config| datapath| events [<count> <mac>]| status}
Description
This command displays details about the Layer-3 (L3) events, mobility configuration, and roaming status of the W-
IAP clients.
Syntax
Parameter Description
config
Displays the L3 mobility configuration details for a W-IAP.
datapath
Displays the datapath statistics associated with L3 mobility.
events [<count> <mac>]
Displays L3 mobility events for all W-IAP clients or individual clients
filtered based on MAC address.
status
Displays the L3 mobility status for a W-IAP.
Usage Guidelines
Use this command to view the L3 mobility information for a W-IAP.
Examples
show l3-mobility config
The following example shows the output of the show l3-mobility config command:
Flags
-----
Type Value
---- -----
Home Agent Load Balancing enable
Virtual Controller Table
------------------------
Virtual Controller IP
---------------------
192.0.1.0
Subnet Table
------------
Subnet Netmask VLAN Virtual Controller
------ ------- ---- ------------------
192.0.2.0 255.255.255.255 2 192.0.1.0
The output of this command provides the following information:
Column Description
Flags
Indicates if any L3 mobility features are enabled.
Type
Indicates the type of the flag.
Value
Indicates if a flag is enabled.
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide show l3-mobility | 403