Reference Guide

432 | show network Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show network
show network <name>
Description
This command shows network configuration details for a W-IAP.
Syntax
Parameter Description
<name>
Displays the name of a network profile.
Usage Guidelines
Use this command without the optional <name> parameter to view a complete configuration details of a network
profile on the W-IAP. Include the <name> parameter to display settings for a single network SSID only.
Example
The following example shows the partial output of show network <name> command:
Name :test
ESSID :test
Status :Enabled
Mode :wpa2-aes
Band :all
Type :employee
Termination :Disabled
Passphrase :
WEP Key :
WEP Key Index :1
VLAN :
Server Load Balancing :Disabled
MAC Authentication :Disabled
L2 Auth Failthrough :Disabled
Captive Portal :disable
Exclude Uplink :none
Hide SSID :Disabled
Content Filtering :Disabled
Auth Survivability :Disabled
Auth Survivability time-out :24
RADIUS Accounting :Disabled
Interim Accounting Interval :0
Radius Reauth Interval :0
DTIM Interval :1
Inactivity Timeout :1000
Legacy Mode Bands :all
G Minimum Transmit Rate :1
G Maximum Transmit Rate :54
A Minimum Transmit Rate :6
A Maximum Transmit Rate :54
Multicast Rate Optimization :Disabled
LEAP Use Session Key :Disabled
Broadcast-filter :none
Max Authentication Failures :0
Blacklisting :Disabled
WISPr :Disabled
Accounting mode :Authentication