Reference Guide

show radio config
show radio config
Description
This command displays the 2.4 GHz and 5 GHz radio configuration details for a W-IAP.
Usage Guidelines
Use this command to view the 2.4 GHz and 5 GHz radio configuration details for a W-IAP.
Example
The following example shows the output of show radio config command:
(Instant AP)# show radio config
Legacy Mode:enable
Beacon Interval:100
802.11d/802.11h:enable
Interference Immunity Level:2
Channel Switch Announcement Count:0
MAX Distance:600
Channel Reuse Type:disable
Channel Reuse Threshold:0
Background Spectrum Monitor:disable
5.0 GHz:
Legacy Mode:enable
Beacon Interval:100
802.11d/802.11h:enable
Interference Immunity Level:2
Channel Switch Announcement Count:2
MAX Distance:600
Channel Reuse Type:disable
Channel Reuse Threshold:0
Background Spectrum Monitor:disable
Standalone Spectrum Band:5ghz-upper
The output of this command provides the following information:
Parameter Description
Legacy Mode
Indicates if the legacy mode is enabled on the W-IAPs to run the radio in the non-
802.11n mode.
Beacon Interval
Displays beacon interval for the W-IAP in milliseconds. When beacon interval is
configured, the 802.11 beacon management frames are transmitted by the
access point at the specified interval.
802.11d/802.11h
Displays if the W-IAP is allowed advertise its 802.11d (country information) and
802.11h (transmit power control) capabilities.
Interference Immunity
Level
Displays the immunity level configured for an AP radio profile to improve
performance in high-interference environments. For more information on
configuring immunity levels, see rf dot11a-radio-profile and rf dot11g-radio-
profile.
Channel Switch
Displays the number of channel switching announcements that are sent before
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide show radio config | 441