Reference Guide

472 | show uplink Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show uplink
show uplink {config|stats}
Description
This command displays uplink configuration details and status of for a W-IAP.
Syntax
Parameter Description
show uplink config
Displays the uplink interface configuration details for a W-IAP.
show uplink stats
Displays the aggregate uplink statistics for a W-IAP
Usage Guidelines
Use this command to view the information about uplink status and configuration for a W-IAP.
Example
The following output is displayed for the show uplink config command:
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink eth0 :DHCP
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
The output of this command provides the following information:
Column Description
Uplink preemption
Indicates if the uplink preemption is enabled.
Uplink enforce
Indicates if any uplinks are enforced.
Ethernet uplink eth0
Indicates if Ethernet uplink is configured.
Max allowed test packet loss
Indicates an allowed number of test packets that can be lost verifying
the Internet availability.
Secs between test packets
Indicates the frequency at which the test packets are sent to verify the
Internet availability.
VPN failover timeout (secs)
Indicates the number of seconds to wait, before trying a different uplink
when a VPN tunnel is down.
The following output is displayed for the show uplink status command:
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink eth0 :DHCP
Uplink Table
------------
Type State Priority In Use
---- ----- -------- ------