Reference Guide

What is New in Instant 6.4.0.2-4.1
This section lists the new and modified commands in the Instant 6.4.0.2-4.1 release.
New Commands
The following commands are added in the Instant 6.4.0.2-4.1 release:
Command Description
console Allows you to enable or disable access to the W-IAP console.
dpi Enables deep packet inspection (DPI) support and allows you to configure DPI for wired or
wireless network users.
inbound-firewall Allows you to configure inbound firewall rules.
mgmt-accounting Enables accounting privileges on TACACS+ servers for management users in Instant.
rft Allows you to run tests for RF troubleshooting.
NOTE: In this release, this command is not available in W-IAP224/225, and W-IAP274/275
platforms.
show console-
settings
Displays if the console access is enabled or disabled on a W-IAP.
show dhcp subnets Displays subnet details and gateway IP address for the distributed L2 and L3 networks.
show dpi Displays the DPI configuration details.
show dpi-stats Displays DPI statistics for application, application category, web category and web reputation
parameters.
show ap dot11k-
beacon-report
Displays the beacon report details for the 802.11k clients of a W-IAP.
show ap dot11k-
nbrs
Displays neighbors for the 802.11k clients of a W-IAP.
show inbound-
firewall-rules
Displays the inbound firewall rule details.
show rft trans-id Displays transaction IDs for the RF test profiles.
show rft profile Displays the profile parameters for the RF tests.
show xml-api-
server
Displays the XML API server configuration details
wlan tacacs-server Configures a TACACS+ server to authenticate management users in Instant.
xml-api-server Integrates an XMLAPIInterface with a W-IAP.
zonename Configures zone settings on a W-IAP.
Table 3: New Commands in 6.4.0.2-4.1
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide About this Guide | 5