Reference Guide

Command/Parameter Description Range Default
decision.
deny-local-routing
Disables the routing traffic
between two clients connected to
the same SSID on different VLANs.
When local routing is disabled, the
clients can connect to the Internet,
but cannot communicate with each
other, and the routing traffic
between the clients is sent to the
upstream device to make the
forwarding decision.
— —
disable
Disables the SSID. By default all
SSIDs are enabled.
— —
dmo-channel-utilization-
threshold
<threshold>
Sets a threshold for DMO channel
utilization. W-IAP sends multicast
traffic over the wireless link.
1–100
percentage
value
90
dot11k
Enables 802.11k roaming on the
SSID profile.
The 802.11k protocol enables W-
IAPs and clients to dynamically
measure the available radio
resources.
When 802.11k is enabled, W-IAPs
and clients send neighbor reports,
beacon reports, and link
measurement reports to each
other.
— —
dot11r
Enables 802.11r on the SSID
profile.
802.11r or fast BSS transition (FT)
is an IEEE standard that permits
continuous connectivity across
wireless devices during client
mobility. Fast BSS Transition
mechanism minimizes the
delay in roaming when a client
transitions from one BSS to
another within the
same cluster.
Fast BSS Transition is operational
only if the wireless client supports
802.11r standard. If the client does
support 802.11r standard, it falls
back to normal WPA2
authentication method.
— —
dot11v
Enables 802.11v based BSS
transition.
— —
dtim-period <value>
Configures the Delivery Traffic
Indication Message (DTIM) interval
1–10
beacons
1
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide wlan ssid-profile | 551