Reference Guide

Command/Parameter Description Range Default
inactivity-timeout <interval>
Configures a timeout value for the
inactive client sessions.
When a client session is inactive
for the specified duration, the
session expires and the clients are
required to log in again.
60-86400
seconds
1000
index <idx>
Assigns an index value for the
SSID.
— —
l2-auth-failthrough
Allows the clients to use 802.1X
authentication when MAC
authentication fails.
— Disabled
leap-use-session-key
Allows the users to derive session
keys for Lightweight Extensible
Authentication Protocol (LEAP)
authentication.
Configure this command for old
printers that use dynamic WEP and
if you do not want use a session
key from the RADIUS Server to
derive pair wise unicast keys.
— Disabled
local-probe-req-thresh
<threshold>
Configures a Received signal
strength indication (RSSI)
threshold value to limit the number
of incoming probe requests.
When enabled, this command
controls the system response to
the broadcast probe requests sent
by clients to search for the
available SSIDs and ignores the
probe request if required,
0-100 dB —
mac-authentication
Enables MAC authentication for
clients that use this SSID profile.
— Disabled
mac-authentication-delimiter
<delim>
Allows you to set a delimiter that
can be used in the MAC address
string for MAC authentication.
You can specify colon or dash for
delimiter. If the delimiter is not
specified, the MAC address in the
xxxxxxxxxxxx format is used. If you
specify colon for the delimiter, the
MAC addresses in the
xx:xx:xx:xx:xx:xx format are used.
colon or
dash
—
mac-authentication-upper-case
Enables the W-IAP to use
uppercase letters in MAC address
string for MAC authentication.
— —
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide wlan ssid-profile | 553