Reference Guide

6 | About this Guide Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
Modified Commands
The following commands are modified in the Instant 6.4.0.2-4.1 release:
Command Description
airgroup This command now allows you to enable DLNA and mDNS (Bonjour services) support on a
W-IAP for the AirGroup enabled clients.
airgroupservice This command now allows you to configure services such as Chromecast, DLNA media,
and DLNAprint services.
ip dhcp This command now allows you to enable or disable split tunnel for Centralized, L2 clients .
l2tpv3 session This command now allows you enable default l2 specific sublayer for the L2TPV3 sessions.
show airgroup This command now includes the DLNA and MDNSoptions to filter the output based on the
DLNA and Bonjour services (mDNS)configuration status.
show airgroupservice The output of this command now displays the disallowed roles and VLANs for the
mDNSand DLNAservices.
show access-rule
The output of this command displays the access rules created for DPI.
show access-rule-all
show auth-survivability The debug-log option is added to the command syntax. On running the show auth-
survivability debug-log command, the logs for troubleshooting the authentication
survivability are displayed.
show dhcps config The output of this command now displays split-tunnel status for centralized,L2 and and DNS
caching status for local or local,l2 profiles.
show vpn This command now displays the IAP-VPN retry counter details when the tunnels keyword is
used.
wlan access-rule This command now allows you to configure access rules for deep packet inspection. The
rule command allows you to create access rules to allow or deny access to certain
application, application categories, website categories, and URLs based on security rating.
In the current release, you can also configure inbound firewall rules based on source
subnet.
wlan ssid-profile This command now allows you to configure AP zone, WMM DSCP traffic mapping, backup
authentication server with termination enabled, and enable fast roaming features such as
802.11k and 802.11v. The command also allows you to disable bridging and routing traffic
between the clients connected to the same SSID.
arm The maximum threshold value of Client Match has been increased to 255. The previous
maximum threshold limit was 20.
Table 4: Modified Commands in 6.4.0.2-4.1