User guide

56 | Managing IAPs Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide
3. Click OK.
Removing an W-IAP from the Network
An W-IAP can be manually removed from the network only if the Auto Join Mode feature is disabled. To
manually remove an W-IAP from the network, perform the following steps:
1. In the Access Points tab, click the W-IAP which you want to delete. An x appears against the W-IAP.
2. Click x to confirm the deletion.
Editing W-IAP Settings
This section explains the steps required to edit the following W-IAP settings:
 Name
 IP Address
 Adaptive Radio Management (ARM) Configuration
 External Antenna Configuration
 Migrating from a Virtual Controller Managed Network to Mobility Controller Managed Network
Changing W-IAP Name
To change the W-IAP name, perform the following steps:
1. In the Access Points tab, click the AP of the W-IAP that you want to rename. The edit link appears.
Figure 44 Editing W-IAP Settings
2. Click the edit link.
NOTE: The deleted W-IAP(s) cannot join the Instant network anymore.