Concept Guide

show ap debug ble-config
show ap debug ble-config {ap-name <ap-name>|ip-addr <ip-addr>|ip6-addr <ip6-addr>}
Description
This command displays the Bluetooth Low Energy (BLE) configuration of the AP. In addition, the command
displays the update interval to the Beacon Management Console (BMC), BLE token, AP Beacon (APB) status,
the last update time to BMC, and the beacon MAC for which the last update was sent.
This command is supported in W-AP210 Series, W-AP220 Series (with external BLE USB), and W-AP320 Series.
Syntax
Parameter Description
ap-name
Displays the BLE configuration of an AP for a specific AP based on the AP
name.
ip-addr
Displays the BLE configuration of an AP for a specific AP based on the IPv4
address.
ip6-addr
Displays the BLE configuration of an AP for a specific AP based on the IPv6
address.
Example
The output of this command displays the update interval to the Beacon Management Console (BMC), BLE
token, AP Beacon (APB) status, the last update time to BMC, and the beacon MAC for which the last update
was sent.
(host) #show ap debug ble-config ap-name ap325
BLE Configuration
-----------------
Item Value
---- -----
LMS IP 192.0.2.1
Authorization Token YzJlNmEzOTMtYjE4MC00ZTc4LWJmNDEtMzMzNGEyY2NjY2RmOj
Y4YzBhOWI2LWYxMGQtNGZlMi05YmVkLTI5ZTY5MDNkYjhmYQ==
Endpoint URL https://edit.meridianapps.com/api/beacons/manage
BLE Ready Yes
Update Intvl (in sec) 300
BLE debug log Enabled
Operational Mode Beaconing (APB: Beaconing)
Uplink Status Up (APB: -NA-)
APB Connection Status 0
Last BLE Device Update Attempt c4:be:84:19:ef:99
Last Update Sent Time 2015-09-27 11:45:50
-----------------
Note: Uplink status is applicable only for Dynamic Console operational mode.
For APBs of type LS-BT1USB, applied operational mode is Beaconing if ap system profile setting
is either Persistent or Dynamic.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug ble-config | 1055