Concept Guide

Table Of Contents
show ap debug client-table
show ap debug client-table [ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>|ip6-addr <ip6-
addr>]
Description
Show clients associated to an AP.
Syntax
Parameter Description
ap-name <ap-name>
Filter the client table by AP name.
bssid <bssid>
Filter the client table by BSSID. This will print clients on top from given BSSID.
ip-addr <ip-addr>
Filter the client table by AP IP address.
ip6-addr <ip-addr>
Filter the client table by AP IPv6 address.
Usage Guidelines
The Tx_Rate, Rx_Rate, Last_ACK_SNR, and Last_Rx_SNR columns shown in the output of this command
display valuable troubleshooting information for clients trying to connect to a specific AP. Use this command
to verify that the transmit (Tx_Rate) and receive (Rx_Rate) rates are not too low, and that the signal-to-noise
(SNR) ratio is acceptable.
Examples
The example below the AP configuration table for a specific BSSID. In this example, the output is divided into
multiple sections to better fit on the pages of this document. In the actual command-line interface, it appears
in a single, long table.
(host) #show ap debug client-table ap-name apname1
Client Table
------------
MAC ESSID BSSID Assoc_State HT_State AID
--- ----- ----- ----------- -------- ---
00:10:18:a9:7c:48 essidname1 6c:f3:7f:e7:5c:90 Associated cAWvSseM 0x1
PS_State UAPSD Tx_Pkts Rx_Pkts PS_Qlen Tx_Retries Tx_Rate Rx_Rate
-------- ----- ------- ------- ------- ---------- ------- -------
Awake (0,0,0,0,N/A,0) 799 1377 0 48 1300 1053
Last_ACK_SNR Last_Rx_SNR TX_Chains Tx_Timestamp
------------ ----------- --------- ------------
32 47 3[0x7] Sun Jul 21 11:05:50 2013
Rx_Timestamp MFP Status (C,R) Idle time Client health (C/R)
------------ ---------------- --------- -------------------
Sun Jul 21 11:05:50 2013 (0,0) 119 90/90
UAPSD:(VO,VI,BK,BE,Max SP,Q Len)
HT Flags: A - LDPC Coding; W - 40MHz; S - Short GI 40; s - Short GI 20
D - Delayed BA; G - Greenfield; R - Dynamic SM PS
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug client-table | 1082