Concept Guide

show ap mesh debug hostapd-log
show ap mesh debug hostapd-log {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
Description
Show the debug log messages for the hostapd process.
Syntax
Parameter Description
ap-name <ap-name>
Show data for an AP with a specific name.
bssid <bssid>
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The
Basic Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr>
Show data for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
Usage Guidelines
This is an internal technical support command. Dell technical support may request that you issue this
command to help analyze and troubleshoot problems with the hostapd process or your mesh network.
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms This show command is
available in the base operating
system. Commands to
configure the mesh feature
require the Mesh license.
Enable or Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap mesh debug hostapd-log | 1194