Concept Guide

Table Of Contents
1254| show ap regulatory-domain-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Valid 802.11a 80MHz channel group 52-64
Valid 802.11a 80MHz channel group 100-112
Valid 802.11a 80MHz channel group 116-128
Valid 802.11a 80MHz channel group 132-144
Valid 802.11a 80MHz channel group 149-161
Valid 802.11a 160MHz channel group 36-64
The output of this command includes the following information:
Column Description
Country Code Code that represents the country in which the APs will operate. The country
code determines the 802.11 wireless transmission spectrum.
Valid 802.11g channel Selected 802.11b/g channel available for use by an AP using the specified
regulatory domain profile. These channels are limited to those valid for the
profile’s country code.
Valid 802.11a channel Selected 802.11a channel available for use by an AP using the specified
regulatory domain profile. These channels are limited to those valid for the
country code.
Valid 802.11g 40MHz
channel pair
Selected 802.11b/g 40 MHz channel pair available for use by an AP using the
specified domain profile. These channels are limited to those valid for the
profile’s country code.
Valid 802.11a 40MHz
channel pair
Selected 802.11a 40 MHz channel pair available for use by an AP using the
specified domain profile. These channels are limited to those valid for the
profile’s country code.
Valid 802.11a 80MHz
channel group
Selected 802.11a 80 MHz channel group available for use by an AP using the
specified domain profile. These channels are limited to those valid for the
profile’s country code.
Valid 802.11a 160MHz
channel group
Selected 802.11a 1600 MHz channel group available for use by an AP using
the specified domain profile. These channels are limited to those valid for the
profile’s country code.
Command History
Version Description
ArubaOS 3.0 Command introduced.
ArubaOS 6.5 The Valid 802.11a 160MHz channel group parameter was introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master
controllers