Concept Guide

show ap spectrum ap-list
show ap spectrum ap-list {ap-name <ap-name>}|{ip-addr <ip-addr>}
ap-bssid <bssid>
channel <channel>
essid <essid>
limit <number>
or
page <number>
freq-band 2.4ghz|5ghz
sort <sort>
start <index>
Description
This command shows spectrum data seen by an access point that has been converted to a spectrum monitor.
Syntax
Parameter Description
ap-name <ap-name>
Name of the spectrum monitor for which you want to view spectrum
information.
ip-addr <ip-addr>
IP address of the spectrum monitor for which you want to view spectrum
information.
channel <channel>
View spectrum information for a specific radio channel.
essid <essid>
View spectrum information for a specific ESSID.
limit <number>
Limit the displayed output to the specified number of entries
or
Use this parameter to display information that meets either of two criteria,
such as a specified ESSID or channel.
page <number>
Enter a number from 10-100 (inclusive) to specify the number of entries that
should appear in each page of the output for this command. For example, if
the output of this command has 100 entries and you select a page value of 20,
the output will appear in 5 pages each with 20 entries. If you selected a page
value of 10, the output would appear in 10 pages with 10 entries.
freq-band 2.4ghz|5ghz
View information for a specific radio type, either 2.4 GHz or 5 Ghz.
sort <sort>
Sort the output by the specified data column
start <index>
Start displaying the output at specific spectrum index value.
Usage Guidelines
The Spectrum Analysis feature provides visibility into RF coverage, allowing you to troubleshoot RF interference
and identify 802.11 devices on the network. Issue this command to display and sort APs seen by a specific
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap spectrum ap-list | 1276