Concept Guide

1326| show ap system-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Dump Server N/A
Heartbeat DSCP 0
Maintenance Mode Disabled
Maximum Request Retries 10
Request Retry Interval 10 sec
Number of IPSEC retries 85
Secondary Master IP/FQDN N/A
AeroScout RTLS Server N/A
RTLS Server configuration N/A
RTLS Server Compatibility Mode Enabled
Slow Timer Recovery by rebooting itself Disabled
Telnet Enabled
Disable RAP Tftp Image Upgrade Disabled
Spanning Tree Disabled
AP multicast aggregation Disabled
AP ARP attack protection Enabled
AP multicast aggregation allowed VLANs none
Console enable Enabled
AP Console Protection Enabled
AP Console Password ********
Password for Backup ********
AP USB Power override Disabled
RF Band for Backup all
Operation for Backup off
BLE Endpoint URL N/A
BLE Auth Token N/A
BLE Operation Mode Disabled
The output of this command includes the following information:
Column Description
RF Band
For dual-band radios, this parameter displays the RF
band in which the AP should operate:
l g = 2.4 GHz
l a = 5 GHz
RF Band for AM mode scanning
Scanning band for multiple RF radios.
l g = 2.4 GHz
l a = 5 GHz
l all = Radio scans both bands. This is the default
setting.
Native VLAN ID
Native VLAN for bridge mode virtual APs (frames on
the native VLAN are not tagged with 802.1q tags).
Tunnel Heartbeat Interval
Interval between heartbeat messages between a
remote or campus AP and its associated controller. An
increase in the heartbeat interval increases the time it
will take for an AP to detect the loss in connectivity to
the controller, but can reduce internet bandwidth
consumed by a remote AP.
Session ACL
This parameter shows the access control list (ACL)
applied on the uplink of a remote AP.