Concept Guide

ap debug client-trace stop
ap debug client-trace stop
{ap-name <ap-name>}|{ip-addr <ip>}|{ip6-addr <ip6>} mac <client-mac>
Description
Use this command to stop tracing management packets from a client MAC address.
Syntax
Parameter Description
ap-name <ap-name>
Name of the AP.
ip-addr <ip-addr>
IPv4 address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
mac <client-mac> MAC address of the client..
Usage Guidelines
This command should only be used under the guidance of Dell technical support.
Related Commands
Command Description
ap debug client-trace
start
Use this command to trace management packets from a client MAC address.
show ap debug cli-
ent-trace
Use this command to show counts of different types of management data frames
traced from a client MAC address
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
All platforms
Base operating system Enable mode on master or local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap debug client-trace stop | 157