Concept Guide

Table Of Contents
show ip access-group
show ip access-group
Description
Display access control lists (ACLs) configured for each port on the controller.
Syntax
No parameters.
Examples
The example below shows part of the output of this command. If a port does not have a defined session ACL,
the Port-Vlan Session ACL table will be blank.
(host) # show ip access-group
FE 1/0:
Rx access list 200 is applied
session access list User14 is applied
Port-Vlan Session ACL
---------------------
SessionACL Vlan Status
---------- ---- ------
coltrane 22 configured
The output of this command includes the following parameters:
Parameter Description
Session ACL
Name of the ACL applied to the interface.
VLAN
If the ACL was applied to a VLAN associated with this port, this column will show the VLAN
ID.
Status
Shows whether or not the session ACL is configured.
Related Commands
Command Description
interface fastethernet | gigabitethernet ip access-
group
Configure an access group for an
interface.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ip access-group | 1584